Volume 4, Number 3 (9-2014)                   IJAE 2014, 4(3): 758-768 | Back to browse issues page


XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Das S, Nayak R, Dhupal D, Kumar A. Surface Roughness, Machining Force and FlankWear in Turning of Hardened AISI 4340 Steel with Coated Carbide Insert: Cutting Parameters Effects. IJAE. 2014; 4 (3) :758-768
URL: http://www.iust.ac.ir/ijae/article-1-275-en.html

Abstract:   (1847 Views)
The current experimental study is to investigate the effects of process parameters (cutting speed, feed rate and depth of cut) on performance characteristics (surface roughness, machining force and flank wear) in hard turning of AISI 4340 steel with multilayer CVD (TiN/TiCN/Al2O3) coated carbide insert. Combined effects of cutting parameter (v, f, d) on performance outputs (Ra, Fm and VB) are explored employing the analysis of variance (ANOVA). An L9 Taguchi standard design of experiments procedure was used to develop the regression models for machining responses, within the range of parameters selected. Results show that, feed rate has statistical significance on surface roughness and the machining force is influenced principally by the feed rate and depth of cut whereas , cutting speed is the most significant factor for flank wear followed by cutting speed. The desirability function approach has been used for multi-response optimization. Based on the surface roughness, machining force and flank wear, optimized machining conditions were observed in the region 147 m/min cutting speed and 0.10 mm/rev feed rate and 0.6 mm depth of cut.
Full-Text [PDF 235 kb]   (1301 Downloads)    
Type of Study: Research | Subject: General
Received: 2014/11/11 | Accepted: 2014/11/11 | Published: 2014/11/11

Add your comments about this article : Your username or email:
Write the security code in the box

© 2015 All Rights Reserved | International Journal of Automotive Engineering

Designed & Developed by : Yektaweb