Namdar P, Saeidi Googarchin H, ghasemi S H. An experimental investigation on the effects of severely plastic deformation process on the mechanical properties of automotive resistance spot welded aluminum joints. ASE 2022; 12 (1) :3737-3749
URL:
http://www.iust.ac.ir/ijae/article-1-589-fa.html
An experimental investigation on the effects of severely plastic deformation process on the mechanical properties of automotive resistance spot welded aluminum joints. Automotive Science and Engineering. 1400; 12 (1) :3737-3749
URL: http://www.iust.ac.ir/ijae/article-1-589-fa.html
چکیده: (8304 مشاهده)
In this paper, mechanical properties of welded single lap joints of pure aluminum sheets produced by severe plastic deformation (SPD) are considered. SPD in form of a large pre-strain was imposed to aluminum sheets through the constrained groove pressing (CGP) process. Furthermore, CGPed specimens are joined using the resistance spot welding (RSW) method. Welding time and force are maintained evenly. Welding current is raised until ideal failure mode is observed. Finally, mechanical properties of fusion zone, heat affected zone (HAZ) and base metal of welded SPDed specimens are derived. The results show that by increasing the pre-strain in specimens, an improvement in yield strength, ultimate tensile strength, load carrying capacity, maximum displacement before failure and nugget diameter is observed. Furthermore, sensitivity of these parameters to CGP pass number is considered. Finally, it has been shown that fusion zone and HAZ hardness values can increase by increasing the CGP pass number.
نوع مطالعه:
پژوهشي |
موضوع مقاله:
سازه