دوره 10، شماره 3 - ( 6-1399 )                   جلد 10 شماره 3 صفحات 3294-3281 | برگشت به فهرست نسخه ها


XML English Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Azmoodeh M R, Keshavarz A, Batooei A, Saberinejad H, Payandeh Doost M, Keshtkar H. Experimental study and thermal analysis of a Gamma type Stirling engine for multi-objective optimization. ASE 2020; 10 (3) :3281-3294
URL: http://www.iust.ac.ir/ijae/article-1-547-fa.html
Experimental study and thermal analysis of a Gamma type Stirling engine for multi-objective optimization. Automotive Science and Engineering. 1399; 10 (3) :3281-3294

URL: http://www.iust.ac.ir/ijae/article-1-547-fa.html


چکیده:   (9402 مشاهده)
A multi-objective optimization and thermal analysis is performed by both experimental and numerical approaches on a Stirling engine cooler and heater. The power generated is measured experimentally by an electrical engine coupled with the crank case, and the friction is estimated by the difference between the necessary power used for rotating the engine at a specific pressure and speed, versus the actual power measured experimentally. In the experimental approach, different conditions were considered; for example, the charge pressure varied from 5-9 bars, and the engine speed varied from 286-1146 rpm. The maximum power generated was 461.3 W and was reported at 9 bars of charge pressure and 1146 rpm engine speed. Numerical approach was carried to simulate thermal balance for investigations on the effect of friction, engine speed and efficiency on generated engine power. Average values of Nusselt number and coefficient of friction were suggested from simulation results.
The multi-objective optimization was held using DOE method for maximizing engine efficiency and power, and also minimizing pressure drop. The top and bottom boundary values for our optimization were 5-9 bars of pressure and 286-1146 rpm of engine speed; for both helium and carbon dioxide. To do so, all three significance factors (engine speed, efficiency and friction) were given different weights, thus different combinations of weight value was investigated
Amongst different interesting findings, results showed that if the efficiency weight factor changed from 1 to 3, for helium in a specific condition, the optimum engine speed would increase by approximately 30.6 %
متن کامل [PDF 1210 kb]   (5631 دریافت)    
نوع مطالعه: پژوهشي | موضوع مقاله: سوخت های جایگزین

ارسال نظر درباره این مقاله : نام کاربری یا پست الکترونیک شما:
CAPTCHA

بازنشر اطلاعات
Creative Commons License این مقاله تحت شرایط Creative Commons Attribution-NonCommercial 4.0 International License قابل بازنشر است.

کلیه حقوق این وب سایت متعلق به مجله بین‌المللی مهندسی خودرو می باشد.

طراحی و برنامه نویسی : یکتاوب افزار شرق

© 2024 CC BY-NC 4.0 | Automotive Science and Engineering

Designed & Developed by : Yektaweb