Automotive Science and Engineering
Automotive Science and Engineering
ASE
Engineering & Technology
http://www.iust.ac.ir/ijae
18
agent2
2717-2023
10.22068/ase
en
jalali
1389
10
1
gregorian
2011
1
1
1
1
online
1
fulltext
fa
Performance Analysis of a Variable Geometry Turbocharger Using Mean Line Method
سیستم های مکاترونیک
Mechatronic systems
پژوهشي
Research
Turbocharging an engine boosts its power by increasing the amount of input air. This task is accomplished by using the exhaust gas to power a turbine which is engaged with a compressor. The Variable Geometry Turbocharger, VGT is a unique turbocharger that the diffuser vane angle can be changed over a wide range of positions. The mathematics of turbomachinery flow analysis is intensive and uses iterative methods. Most of the flow analyses in the area of turbochargers are either experimental or numerical. Three-dimensional Computational Fluid Dynamics (CFD), two-dimensional multiple streamline and one dimensional mean line is the three primary numerically available methods. In this paper a mean line method has been used for predicting the performance of a centrifugal compressor with variable diffuser vane angle position at subcritical Mach numbers. The calculation is based on common thermodynamic and aerodynamic principles, and empirical correlations for losses in a mean line analyses. The model calculates the velocities, pressures, temperatures, pressure losses, work consumption, and efficiencies for a specified set of turbocharger geometry, atmospheric conditions, rotational speed, and fluid mass flow rate. The obtained numerical results are validated with the in house measured experimental data and good agreement observed. The purpose for compressor model analysis is to generate overall characteristic map and identify the impact of the diffuser vane angles on the performance. The overall characteristic map is generated by this method demonstrate very good agreement and the effect of variable vane angle in pressure ratio and operating range observed.
mean line method, turbocharger, centrifugal compressor, performance
47
55
http://www.iust.ac.ir/ijae/browse.php?a_code=A-10-33-1&slc_lang=fa&sid=1
J.
Mahdavinia
mahdavinia.javad@gmail.com
`18003194753284600538`

18003194753284600538
Yes
Department of Mechanical Engineering, K.N.Toosi University of Technology
A.
Keshavarz
`18003194753284600539`

18003194753284600539
No
M.H.
Moshrefi
`18003194753284600540`

18003194753284600540
No