Volume 4, Number 1 (3-2014)                   IJAE 2014, 4(1): 654-663 | Back to browse issues page


XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Honarvar Gheysari, Babakhani, Haerian. Study and Simulation of Shot peening Effect on Fatigue Life of a Powder Forged Connecting rod. IJAE. 2014; 4 (1) :654-663
URL: http://www.iust.ac.ir/ijae/article-1-253-en.html

Abstract:   (1706 Views)
Shot peening applies a residual compressive stress field (RCSF) on the surface of parts. It also shifts “crack nucleation sites” to sub-surface locations. A nondestructive method of measuring the stresses, Sin2ψ was utilized here and the stress values introduced to Ansys software. For this purpose, uniform stress in all directions was applied on the con rod. Loading on the rod in Ansys had three steps: RCSF caused by shot peening (measured by XRD), and tensile and compressive stresses caused by inertial and gas forces, respectively (calculated). Fatigue Macro of Ansys was resumed carrying out the cyclic loading and thereby, improvement of powder forged connecting rods' fatigue life, caused by shot peening was obtained.
Full-Text [PDF 841 kb]   (1236 Downloads)    
Type of Study: Research | Subject: General
Received: 2014/06/16 | Accepted: 2014/06/16 | Published: 2014/06/16

Add your comments about this article : Your username or email:
Write the security code in the box

© 2015 All Rights Reserved | International Journal of Automotive Engineering

Designed & Developed by : Yektaweb